Whole-Home Rewiring in Park City, Utah
Knob-and-tube, cloth-insulated and ungrounded wiring replaced with modern grounded circuits in Park City — planned around your house, permitted, and warrantied for five years.
- Knob-and-tube and cloth-insulated wire replacement
- Ungrounded circuit conversion
- Aluminum branch circuit remediation
- Phased or whole-house, planned around you living there
Get your free Park City quote
Rewiring is the job people put off longest and regret waiting on most. In Park City it comes up for a specific reason. Old Town Park City holds mining-era houses that have been remodeled many times, while Park Meadows and Deer Valley hold large homes with snowmelt, spa and multi-EV loads.
What rewiring means in a Park City house
Old Town Park City holds mining-era houses that have been remodeled many times, while Park Meadows and Deer Valley hold large homes with snowmelt, spa and multi-EV loads. Here is what that means on the ground.
Rewiring an older house is a routing problem before it is an electrical one. Where the wire can travel through the structure decides how much finish comes off, and that decides most of the cost. We walk it and plan it before we open anything.
Snowmelt systems, heat tape, hot tubs and winter EV charging make Park City the heaviest per-home electrical load in our service area, and the load calculation is the whole job. We rewire throughout Park City and Summit County, and we can phase the work so the house stays livable while it happens.
What we do for Park City homeowners
Knob-and-Tube Replacement
The original wiring method in pre-1950 homes. It has no ground, its insulation embrittles with age, and insurers frequently will not write a policy over it.
Cloth-Insulated Wire
Mid-century cloth-covered branch wiring cracks and sheds at the terminations, which is exactly where the heat is. Replacement is the only real fix.
Aluminum Branch Circuits
Late-60s and early-70s aluminum branch wiring has known connection failure modes. Remediation ranges from approved connectors to full replacement.
Ungrounded Circuit Conversion
Two-prong outlets throughout a house mean no equipment ground. Modern electronics and appliances assume one is there.
Phased Rewires
Not everyone can move out. We can rewire a floor, a wing or a circuit group at a time so the house stays livable through it.
Plaster and Finish Planning
Old lath-and-plaster and masonry construction decide the routing. We plan the access before we open anything.
Local, licensed and on time
- We plan the routing first — in an old Park City house, how we get the wire there determines the cost more than the wire does.
- Permitted and inspected — we pull the Park City permit and schedule inspections, and you get the documentation.
- Five-year warranty — on our workmanship throughout the rewire.
- Livable phasing — where a full rewire is not practical at once, we sequence it so you keep your kitchen and your bedrooms.
Park City permits and power
Permits: we pull the Park City electrical permit where the work requires one and schedule the inspection.
Power company: Rocky Mountain Power serves Park City. We coordinate the meter disconnect and reconnect for panel and meter work.
Local conditions: Snowmelt systems, heat tape, hot tubs and winter EV charging make Park City the heaviest per-home electrical load in our service area, and the load calculation is the whole job.
You never deal with the city or the utility. That is our job.
Whole-Home Rewiring service across Park City
We work throughout Park City and Summit County, including Old Town and Deer Valley.
Common questions
How do I know if my Park City home has knob-and-tube?
Look in the attic or an unfinished basement for individual wires running through white ceramic tubes and knobs rather than a single cable. If your house predates 1950 and has two-prong outlets, it is worth an inspection either way.
Will my insurer make me rewire?
Many carriers will not write or renew a policy on active knob-and-tube, and some ask about aluminum branch wiring specifically. If your carrier has raised it, bring us the letter and we will scope to what they are asking for.
Do we have to move out?
Often not. We can phase the work so you keep a functioning kitchen, bathroom and bedrooms throughout. Whole-house-at-once is faster and usually cheaper per circuit, and we will lay out both options.
Does rewiring include a new panel?
Frequently, yes — a rewire is the natural moment to correct an undersized or hazard-brand service, and doing both together costs less than doing them a year apart.
How much drywall or plaster gets opened?
Less than people expect. We fish where we can and cut where we must, and we mark the plan with you before anything opens. Patching can be included in the scope if you want it handled.
Other electrical services in Park City
Whole-Home Rewiring near Park City
Not sure what it will take?
Run the numbers yourself with our free EV charger, panel-upgrade, energy and generator calculators. No email required.
Thinking about rewiring your Park City home?
Licensed, insured and ready now. Free estimates, upfront pricing, five-year warranty.
